To turn Hypervisor off on windows from a command window: “bcdedit /set hypervisorlaunchtype off” and reboot. To turn it back on: “bcdedit /set hypervisorlaunchtype on” and reboot.
To disable Hyper-V using BCDEdit : Press the Win key and type cmd. Right-click on the Command Prompt and select Run as administrator. In the Command Prompt window, type the following command and press Enter: bcdedit / set hypervisorlaunchtype off When the success message appears, close the Command Prompt, and restart your PC to apply the changes.
Make sure Hyper-V is not enabled. If it’s just checked, uncheck it and click OK. 2. You open a command line window, basically the admin panel, you see the type of launch of the hypervisor in case it needs to be restored. Run bcdedit /set hypervisorlaunchtype off to disable the hypervisor. Close the command prompt after executing the commands to reboot the system.
If even creating the registry doesn’t work for you, try “bcdedit /set hypervisorlaunchtype off” with cmd as administrator. PS: If the registry settings help, there may be an active UEFI lock. Delete secure startup keys, restart Windows and reset settings, then install convenient startup keys.
Below you can see that “No Hyper-V” is set very strictly and the current “Hypervisor Startup Type” is often set to “Disabled”. I’ve dragged and dropped into the new interface that our organization has. Rethinking both at the same time. Seen by the Intel Processor Identification Utility.
BCDEDIT /Set current hypervisorlaunchtype auto Reboot your computer normally after running the above BCDEDIT command. The hypervisor now automatically starts the computer on boot. Launch an excellent administrative command prompt and run BCDEDIT to verify that your entry now exists to automatically start the hypervisor.
What is Bcdedit set Hypervisorlaunchtype off?
Run bcdedit /set hypervisorlaunchtype off to disable the hypervisor. After executing the commands, close the command prompt and reboot the system.
What does Bcdedit set Hypervisorlaunchtype off do?
Click Yes to enter administrative rights. To disable Hyper-V, enter the following commands, marking “Enter” bcdedit /set hypervisorlaunchtype off. This will disable Hyper-V until it is enabled normally again.
How do I turn off Bcdedit set Hypervisorlaunchtype?
Run the following command to remove Hyper-V features from Windows 10:
What is Bcdedit set Hypervisorlaunchtype?
BCDEDIT /Set Current Auto Insurance Hypervisor Launch Type Quickly issue an administrative command and run BCDEDIT to verify that this is usually the current entry for the Instant Launch Hypervisor. All of them are designed to work or create almost in Hyper-V.Jum. Thu 20 1436 AH
What is BCDEdit set Hypervisorlaunchtype?
BCDEDIT /Set current hypervisorlaunchtype car Start an administrative command prompt and run BCDEDIT to verify that there is now an entry to automatically start the hypervisor in normal mode. You are ready to rollback or start Hyper-V virtual machines.
What does Bcdedit set Hypervisorlaunchtype auto do?
BCDEDIT / Set current hypervisor startup type to automotive Start an administrative command prompt and run BCDEDIT to verify that there is now an entry to automatically start the hypervisor in normal mode. Everything is ready to use or create virtual machines in Hyper-V.

Ermias is a tech writer with a passion for helping people solve Windows problems. He loves to write and share his knowledge with others in the hope that they can benefit from it. He’s been writing about technology and software since he was in college, and has been an avid Microsoft fan ever since he first used Windows 95.