For resolving The Windows Remote Access Service (RAS) has encountered an error problem, Please follow the below step; Navigate to Windows Device Manager –> Network Adaptores and uninstall the WAN Miniport (IP) and WAN Miniport (PPTP) devices, then scan for the hardware changes. Once it done the hardware changes try to use the NetExtender.
I hope someone can help my routine to solve this problem. Go to Windows Services Manager, run “services.msc”, then look for “Remote Access Automatic Connection Manager” and “Access Connection Manager” to see if these two services are running. If not, configure them automatically to start restarting the merged machine with NetExtender installation/configuration all over again.
Go to Windows Device Manager Network -> Adapters and remove the WAN Miniport (IP) and WAN Miniport (PPTP) devices, then check for changes to the Generic Series Bus. After that, replace the screws and bolts and try using the NetExtender.
ten errors Windows & NetExtender, RAS. The solution was to remove all miniports: once nettextender was open on some login screens, I did it all. Removed the 8 WAN miniports that were showing up on my test machine, analyzed the garden changes, waited for them to sync, then tried Nettextender and that was it! I had another client who was rebooting to work in the marketplace for FWIW.
How to fix SonicWall netextender Windows Remote Access service error?
Instead of tampering with Device Manager, the following installation guide solves the problem: Uninstall SonicWall NetExtender. Restart the system. Reinstall SonicWall NetExtender. Restart the system. Reconfigure VPN connection. Relate. (The first step probably has a similar effect to removing the network adapter device.)
Is the SonicWall netextender service service marked as an interactive service?
The peculiarity of the SonicWall NetExtender service is that it is an interactive service. However, the configuration is configured so that the skills are not interactive. Therefore, this service may not work correctly. Follow the methods below:
How to stop the netextender remote access service?
Open Task Manager, go to Services, look into RAS or RasMan, right click to remember, select Go to Details and it will call the correct process svchost.exe – End Task for Service. If you need services, go back and start RAS i and then try connecting through NetExtender again.

Ermias is a tech writer with a passion for helping people solve Windows problems. He loves to write and share his knowledge with others in the hope that they can benefit from it. He’s been writing about technology and software since he was in college, and has been an avid Microsoft fan ever since he first used Windows 95.