Method 1: Disconnect All Your USB Devices. If you connect many different USB devices on your computer, then
Method 2: Check Your Hard Drive Cables. You can meet “the computer restarted unexpectedly loop Windows 10” error when
Method 3: Use Windows 10 Recovery Drive. If you still keep
When you receive a wonderful error message that says “Mobile Computing Device restarted unexpectedly or encountered an error. Windows installation cannot continue. To install Windows, click OK, restart your computer, and run a clean install.” Windows 10 or upgrade to Windows 10, you are not alone.
Also, if the computer is stuck in an unexpected restart loop, the message “The computer restarted immediately or encountered an unexpected error. “Windows Setup cannot continue” message during filtering. The problem may occur when the BIOS settings are configured incorrectly. In addition, there may be problems with the PC.
The computer restarted unexpectedly or just encountered an unexpected error. In some cases, you may encounter the error message “The computer restarted unexpectedly or encountered an unexpected error.
How to fix the computer restarted unexpectedly loop Windows 10?
Step 2: Click Repair Your Computer, then go to Troubleshoot > Advanced Options. Step 3: On the Advanced Options screen, click on Automatic Repair. Step 4: Wait for the process to complete and restart your computer to check until the “Computer restarted unexpectedly in Windows 10 orbit” error is resolved.
Why does my computer say the computer restarted unexpectedly or encountered an unexpected error?
The computer restarted unexpectedly or encountered an unexpected error. The installer is receiving services – This error can occur due to your startup settings. If you encounter this, you may need to adjust your configurations accordingly.
How do you fix the computer restarted unexpectedly or encountered an unexpected error Windows installation Cannot proceed?
Boot from an actual USB stick, and when someone sees the computer restart without the warning error message, press Shift + F10 if you want to open a command prompt. After unpacking the command line, type diskpart and press Enter. Enter the database and press Enter. Select volume 1 enabled.

Ermias is a tech writer with a passion for helping people solve Windows problems. He loves to write and share his knowledge with others in the hope that they can benefit from it. He’s been writing about technology and software since he was in college, and has been an avid Microsoft fan ever since he first used Windows 95.